Hi guys
Big thanks to all but I have a small issue that may be easily resolved.
After changing HDMI2 to dts mode my hdmi-cec is on HDMI2 is not behaving correctly. If I select anynet+ it goes to HDMI1 input not HDMI 2. I only have an input on HDMI2 so its not getting confused by another source. I have an es6500 that was on firmware 2007. I reapplied the dump to HDMI2 and still the same. I downgraded to 1042 and factory reset from the service menu and still the same.
It works as expected if I use HDMI3.
Any ideas?
Cheers
Big thanks to all but I have a small issue that may be easily resolved.
After changing HDMI2 to dts mode my hdmi-cec is on HDMI2 is not behaving correctly. If I select anynet+ it goes to HDMI1 input not HDMI 2. I only have an input on HDMI2 so its not getting confused by another source. I have an es6500 that was on firmware 2007. I reapplied the dump to HDMI2 and still the same. I downgraded to 1042 and factory reset from the service menu and still the same.
It works as expected if I use HDMI3.
Any ideas?
Cheers
Statistics: Posted by Modul8 — Sun Oct 30, 2016 11:23 pm — Replies 116 — Views 8660